Product details
All standard Gruenberg ovens can be designed to house volatile atmospheres. Thermal Product Solutions designs all solvent venting and drying ovens to conform to OSHA, NFPA 86A, Factory Mutual (FM) and Factory Insurance Association (FIA) requirements. As part of the safety design, solvent venting ovens must be equipped with a high exhaust rate: because the heating elements are an ignition source, a high exhaust rate is needed to dilute the volatile vapors below the “lower explosive limits.” As a result, the heating elements’ kW must be sufficiently increased to compensate for the heat loss caused by the above-normal exhaust rate. In addition, for a solvent venting oven to be energy efficient, the additional kW required must be carefully calculated according to solvent load and operating temperature requirements.
All standard Gruenberg ovens can be designed to house volatile atmospheres. Thermal Product Solutions designs all solvent venting and drying ovens to conform to OSHA, NFPA 86A, Factory Mutual (FM) and Factory Insurance Association (FIA) requirements. As part of the safety design, solvent venting ovens must be equipped with a high exhaust rate: because the heating elements are an ignition source, a high exhaust rate is needed to dilute the volatile vapors below the “lower explosive limits.” As a result, the heating elements’ kW must be sufficiently increased to compensate for the heat loss caused by the above-normal exhaust rate. In addition, for a solvent venting oven to be energy efficient, the additional kW required must be carefully calculated according to solvent load and operating temperature requirements.
- Explosion venting: pressure relief latches, caged or hinged explosion relief panels
- Heating systems interlocked by differential switches
- Purge timer
- Fail safe, separate, manual reset, high limit thermostat
- Door switch
- Separate power exhaust
- Designed to conform to OSHA, NFPA 86, Factory Mutual (FM), and Factory Insurance Association (FIA) requirements for assured process safety.
- Rugged CHIL construction of the Gruenberg Solvent Venting Class A Oven provides years of worry-free use
- Energy efficient design
CHIL Construction
- Separated, insulated inner and outer surfaces
- Pliable, final seal silicone rubber gaskets on oven up to 650°F
- Less energy to maintain temperature
- Air-conditioning equipment doesn’t work as hard
- Heavy duty construction
- Built around welded, structural steel frame
- One-piece unitized construction costs less to install
- Pre-tested, ready for operation
- Motor and blowers to circulate air for uniform atmosphere
- V.F.D. motor for circulation adjustment (CFM)
- Heater elements are Inconel sheathed